What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 17.06.2025 05:10

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Edit 2024–10.
How do women feel when they are in love?
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There are two important concepts here.
He then asserts :
a photo is worth a thousand words.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Why did Obito, a supposed "bad person," do good things for Kakashi?
One is “what exactly is in a ‘surge protector’ ? ”
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
What are 5 ways that can be done by the community to improve the public transport system?
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
It also is a device that limits the change in current flow.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
so, what happens?
Spiraling with ChatGPT - TechCrunch
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Barnstars:
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Is Tinder the best dating app?
2024–10–16 [ OO OLAOYE OYEBODE ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
These devices are installed between the “hot” and “neutral” and protective ground.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Now when you have a certain ac resistance, then a current flows in a loop.
2024–10–10[John johnson John Johnson ]
Do women like watching men sucking men?
The other is “what does a “fuse” do?”
He then describes the function of a fuse.
In schematic diagrams this is the symbol for a fuse:
Are landlords allowed to make unreasonable requests?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
At least they know the answer if they wanted it.
This is where the MOV conducts again, and dissipated the energy.
Does Donald Trump have low self-esteem?
but I think this circuit , shows a few more pieces.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
For this case there are devices called Metal oxide varistors (MOV).
What can you do if someone makes a false accusation against you?
The bolt then partially travels down the line to your home.
These are simplified answers to the original question, and does not change anything I wrote above.
Here is a simplified AC power diagram.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
At one ohm, the resistor has a maximum of 1 watt power.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
but this device (an Inductor) … impedes the rapid changes in the current.
This one hit behind the barn.
Upvotes:
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
But it can get overloaded, and no longer works.
nine
A circuit breaker is similar, but is resettable.
What is lightning?
(Dc diagram shown, AC is similar).
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This device then solves the entire problem.
eight
First Sentence:
But… the neutral is now “floating” because of the 1 ohm resistance.
One
It seems Mohan does not understand the difference between a comment and an Answer.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
what exactly is a ‘surge’ protector?
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
This is 'the assistant's answer'
An AC voltage/ current source, and an ac inductive load.
[image of Common-mode choke]
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
The third is lightning and “how it gets conducted into a home.”
Because the load is inductive, the current lags the voltage.(by a bit).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
[old diagram got deleted by accident]
I post the exact comment here.
The MOV will conduct when the voltage exceeds 50% of line voltage.
A fuse is a non-resetable over current circuit protector.
This is where this question deviates from being a 'generic' question, and becomes more specific.
the problem then depends on "how fast does the fuse operate?".
There are three different concepts here that are getting confused.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
He then describes Rainy Season and Lightning.
What does a fuse do?